Inserting Additional Main Memory In The Processor - Barco TransForm A Service Manual

4.1 Inserting additional main memory in the Processor

Depending on type and configuration of the P
P type standard configuration
ROCESSOR
2×256 MB DDR RAM
AGS-3328-1/-2
2×512 MB DDR2 RAM
AGS-3389-0/-1
2×1 GB DDR2 FB RAM
AGS-3390-1/-2
Before inserting additional main memory Check the feasibility of additional main memory
before starting the procedure, please refer to sections
configuration
It is highly recommended to get DIMMs from Barco. Please, refer to section
of the TransForm A user's manual. If you use other memory modules Barco cannot
guarantee for proper and stable system function.
Memory modules are made of delicate electronic components that are extremely sensitive
to static electricity. Ordinary amounts of static from your clothes or work environment can
destroy them. Transport memory modules only in the original packaging as delivered from
the manufacturer. Handle them only by the edges. Do not touch the components. Use a
grounded workplace and wear a grounding wrist strap; at least, discharge your body's static
electricity by touching a grounded surface, e. g., a properly grounded system's metal
chassis.
Barco – TransForm A – DOC-3358-2 – service manual – Revision 06 – March 2007
ROCESSOR
and 4.3.5 System load within a Processor configuration
Slot 1 Channel A
Slot 3 Channel A
Slot 2 Channel B
Slot 4 Channel B
it can be enhanced with additional memory.
maximal advisable system memory
(depending on configuration of the system)
2 GB
3 GB
4 GB
4.3.4 System load within an OmniBus
respectively.
Bank 1 Slot A
Bank 2 Slot A
Bank 3 Slot A
Bank 4 Slot A
Inserting additional memory, AGS-3398 (left) and AGS-3390-1/-2 (right)
__________________________________________________________________________
Table 4-1
order numbers
Figure 4-1
4-2