Storm-Control Flowcontrol; Vlan - Planet WGSW-24000 User Manual

1000M
8.6.62.1 no storm-control broadcast
This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port
exceeds the high threshold percentage (as represented in "Broadcast Storm Recovery Thresholds" table)
of the link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to the low
threshold percentage or less. The full implementation is depicted in the "Broadcast Storm Recovery
Thresholds" table.
▫
Format no storm-control broadcast
▫
Mode Global Config
Link Speed
10M
100M
1000M

8.6.63 storm-control flowcontrol

This command enables 802.3x flow control for the switch.
This command only applies to full-duplex mode ports.
Note
:
▫
Default Disabled
▫
Format storm-control flowcontrol
▫
Mode Global Config
8.6.63.1 no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
This command only applies to full-duplex mode ports.
Note
:
▫
Format no storm-control flowcontrol
▫
Mode Global Config

8.6.64 vlan

This command creates a new VLAN and assigns it an ID. The ID is a valid VLAN identification number
(ID 1 is reserved for the default VLAN). VLAN range is 2-4094.
▫
Format vlan <2-4094>
▫
Mode VLAN database
5
Table 7-1 Broadcast Storm Recovery Thresholds
High
20
5
5
2
Low
10
2
2