Speed; Speed All; Storm-Control Broadcast - Planet WGSW-24000 User Manual

string of up to 64 characters. To use spaces as part of a description, enclose it in double quotes like: "Port
1 connect to Ln 1"
▫
Format description <description>
▫
Mode Interface Config

8.6.60 speed

This command sets the speed and duplex setting for the interface.
▫
Format speed {{100 | 10} {half-duplex | full-duplex} | 1000 fullduplex}
▫
Mode Interface Config
Acceptable values are:
100BASE-T half-duplex
100h
100BASE-T full duplex
100f
10BASE-T half duplex
10h
100BASE-T full duplex
10f

8.6.61 speed all

This command sets the speed and duplex setting for all interfaces.
▫
Format speed all {{100 | 10} {half-duplex | full-duplex} | 1000 fullduplex}
▫
Mode Global Config
Acceptable values are:
100BASE-T half-duplex
100h
100BASE-T full duplex
100f
10BASE-T half duplex
10h
100BASE-T full duplex
10f

8.6.62 storm-control broadcast

This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet port
exceeds the high threshold percentage (as represented in "Broadcast Storm Recovery Thresholds" table)
of the link speed, the switch discards the broadcasts traffic until the broadcast traffic returns to the low
threshold percentage or less. The full implementation is depicted in the "Broadcast Storm Recovery
Thresholds" table.
▫
Format storm-control broadcast
▫
Mode Global Config
Link Speed
10M
100M
High
20
5
Low
10
2