Spanning-Tree; Spanning-Tree Bpdumigrationcheck; Description - Planet WGSW-24000 User Manual

Note: This command is valid only when the Link Up/Down Flag is enabled (see "snmpserver enable traps
linkmode").
▫
Format snmp trap link-status all
▫
Mode Global Config
8.6.56.1 no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see "snmpserver enable traps
linkmode").
▫
Format no snmp trap link-status all
▫
Mode Global Config

8.6.57 spanning-tree

This command sets the STP mode for a specific port-channel (LAG). This is the value specified for STP
Mode on the Port Configuration Menu. 802.1D mode is the default. The interface is a logical slot and port
for a configured port-channel. The all option sets all configured port-channels (LAGs) with the same
option.
▫
Format spanning-tree {<logical slot/port> | all} {off | 802.1d | fast}
▫
Mode Global Config
The mode is one of the following:
IEEE 802.1D-compliant STP mode is used
802.1d
Fast STP mode is used
fast
STP is turned off
off

8.6.58 spanning-tree bpdumigrationcheck

This command enables BPDU migration check on a given interface. The all option enables BPDU
migration check on all interfaces.
▫
Format spanning-tree bpdumigrationcheck {<slot/port> | all}
▫
Mode Global Config
8.6.58.1 no spanning-tree bpdumigrationcheck
This command disables BPDU migration check on a given interface. The all option disables BPDU
migration check on all interfaces.
▫
Format no spanning-tree bpdumigrationcheck {<slot/port> | all}
▫
Mode Global Config

8.6.59 description

This command sets the description information for the interface. The description is an alphanumeric