Table of Contents
Advertisement
▫
Format
match [not] protocol {<protocol-name> | <0-255>}
▫
Mode
Class-Map Config
9.4.12 match source-address mac
This command adds to the specified class definition a match condition based on the source MAC
address of a packet. The <address> parameter is any layer 2 MAC address formatted as six, two-digit
hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <macmask> parameter is a
layer 2 MAC address bit mask, which need not be contiguous, and is formatted as six, two-digit
hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc). The optional [not] parameter has the
effect of negating this match condition for the class (i.e., match all source MAC addresses except for
what is specified here).
▫
Default
None
▫
Format
match [not] source-address mac <address> <macmask>
▫
Mode
Class-Map Config
9.4.13 match srcip
This command adds to the specified class definition a match condition based on the source IP address of
a packet. The <ipaddr> parameter specifies an IP address. The <ipmask> parameter specifies an IP
address bit mask; note that although it resembles a standard subnet mask, this bit mask need not be
contiguous. The optional [not] parameter has the effect of negating this match condition for the class (i.e.,
match all source IP addresses except for what is specified here).
▫
Default
None
▫
Format
match [not] srcip <ipaddr> <ipmask>
▫
Mode
Class-Map Config
9.4.14 match srcl4port
This command adds to the specified class definition a match condition based on the source layer 4 port
of a packet using a single keyword or numeric notation or a numeric range notation.
To specify the match condition as a single keyword notation, the value for <portkey> is one of the
supported port name keywords (listed below).
The currently supported <portkey> values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet,
tftp, www. Each of these translates into its equivalent port number, which is used as both the start and
end of a port range.
To specify the match condition as a numeric value, one layer 4 port number is required. The port number
is an integer from 0 to 65535.
To specify the match condition as a range, rwo layer 4 port numbers are required and together they
specify a contiguous port range. Each port number is an integer from 0 to 65535, but with the added
requirement that the second number be equal to or greater than the first. The optional [not] parameter
Advertisement
Table of Contents
