Radius Server Key; Radius Server Msgauth; Radius Server Primary; Radius Server Retransmit - Planet WGSW-24000 User Manual

▫
Format no radius server host {auth | acct} <ipaddress>
▫
Mode Global Config

10.1.17 radius server key

This command is used to configure the shared secret between the RADIUS client and the RADIUS
accounting / authentication server. Depending on whether the 'auth' or 'acct' token is used, the shared
secret will be configured for the RADIUS authentication or RADIUS accounting server. The IP address
provided must match a previously configured server. When this command is executed, the secret will be
prompted. The secret must be an alphanumeric value not exceeding 20 characters.
▫
Format radius server key {auth | acct} <ipaddr>
▫
Mode Global Config

10.1.18 radius server msgauth

This command enables the message authenticator attribute for a specified server.
▫
Default radius server msgauth <ipaddr>
▫
Mode Global Config

10.1.19 radius server primary

This command is used to configure the primary RADIUS authentication server for this RADIUS client.
The primary server is the one that is used by default for handling RADIUS requests. The remaining
configured servers are only used if the primary server cannot be reached. A maximum of three servers
can be configured on each client. Only one of these servers can be configured as the primary. If a primary
server is already configured prior to this command being executed, the server specified by the IP address
specified used in this command will become the new primary server. The IP address must match that of a
previously configured RADIUS authentication server.
▫
Format radius server primary <ipaddr>
▫
Mode Global Config

10.1.20 radius server retransmit

This command sets the maximum number of times a request packet is re-transmitted when no response
is received from the RADIUS server. The retries value is an integer in the range of 1 to 15.
▫
Default 10
▫
Format radius server retransmit <retries>
▫
Mode Global Config
10.1.20.1 no radius server retransmit
This command sets the maximum number of times a request packet is re-transmitted, when no response
is received from the RADIUS server, to the default value, i.e. 10.