Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1165

BGP Commands
output definitions (continued)
Nbr Address
(0)
degPref
-> show ipv6 bgp path ipv6-addr 2020:100:200:1::/64
BGP Path parameters
Path address = 2020:100:200:1::
Path Length = 64
Path protocol = ibgp
Path neighbor = peer(2001:100:3:4::1)
Path nextHop
Path origin
Path local preference
Path state
Path weight
Path preference degree
Path autonomous systems = [nAs=0] : <none>,
Path MED
Path atomic
Path AS aggregator
Path IPaddr aggregator
Path community
Path Originator Id
Path Cluster List
Path unknown attribute
output definitions
Path address
Path Length
Path protocol
Path neighbor
Path nextHop
Path origin
Path local preference
Path state
Path weight
OmniSwitch CLI Reference Guide
The IP or IPv6 address of the BGP peer that advertises this path.
The origin attribute of this route path. A question mark (?) indicates
incomplete, and i indicates IGP, and an e indicates EGP.
The local preference value assigned to this route path.
= 2001:100:3:4::1,
= igp,
= 100,
= active,
= 0,
= 100,
= <none>,
= no,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>
The IPv6 address for route path.
The prefix length of the IPv6 path.
The protocol from which this route path was learned. Possible values
for this field are as follows: local, static, directhost, rip, ospf, isis,
ibgp, ebgp, and other.
The IPv6 address of the BGP peer.
The next hop along the route path.
The BGP origin attribute. Possible values will be igp, egp, incomplete,
and none. The origin attribute is considered during the route decision
process.
The local preference value for this route as received in an UPDATE
message. A negative value (for example, the -1 in the above display)
indicates that the local preference value is missing for this route path.
Indicates the state of the path.The possible states are best, feasible, pol-
icy-wait, un-synchronized, dampened, or none. When path state is
none, it indicates that there are no paths to this prefix and the route is
being purged from the system.
The path weight as assigned through inbound and outbound policies.
March 2011
show ipv6 bgp path
page 19-197