Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1214

ip slb cluster
•
SLB clusters are not active if the Server Load Balancing feature is disabled for the switch. Use the
slb admin-state
Note
It is possible to configure clusters and add or remove servers from a cluster even when SLB is disabled for
the switch.
Examples
-> ip slb cluster corporate_servers vip 1.2.3.4
-> ip slb cluster "mail servers" vip 1.2.3.6
-> ip slb cluster cluster_1 condition intranet_cond l2
-> ip slb cluster cluster_2 condition slb_cond l3
-> no ip slb cluster hr_servers
Release History
Release 7.1.1; command introduced.
Related Commands
show ip slb clusters
show ip slb cluster
ip slb admin-state
ip slb server ip cluster
MIB Objects
slbClusterTable
slbClusterName
slbClusterVIP
slbClusterRowStatus
slbClusterPackets
slbClusterCondition
slbClusterType
page 20-6
command to enable this feature.
Displays the status and configuration of all Server Load Balancing clus-
ters on a switch.
Displays detailed status and configuration information for a single
Server Load Balancing cluster on a switch.
Enables or disables Server Load Balancing on a switch.
Adds, deletes, or modifies parameters of physical servers in logical
Server Load Balancing clusters.
Server Load Balancing Commands
OmniSwitch CLI Reference Guide
ip
March 2011