Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1516

show ipv6 pim interface
output definitions (continued)
Effective Override Interval
Suppression Enabled
DR Priority Enabled
Stub Interface
Prune Limit Interval
Graft Retry Interval
SR Priority Enabled
Operational Status
Release History
Release 7.1.1; command was introduced.
Related Commands
ipv6 pim interface
MIB Objects
alaPimInterfaceTable
alaPimInterfaceIfIndex
alaPimInterfaceDR
alaPimInterfaceHelloInterval
alaPimInterfaceJoinPruneInterval
alaPimInterfaceStatus
alaPimInterfaceAddress
alaPimInterfaceTrigHelloInterval
alaPimInterfaceHelloHoldtime
alaPimInterfaceJoinPruneHoldtime
alaPimInterfacePropagationDelay
alaPimInterfaceOverrideInterval
alaPimInterfaceGenerationIDValue
page 23-102
The Effective Override Interval on this interface.
Specifies whether the Join suppression is enabled on this interface.
Evaluates to TRUE if all routers on this interface are using the DR Pri-
ority option.
Specifies whether this interface is a 'stub interface'. If this is TRUE,
then no PIM packets are sent out on this interface, and any received
PIM packets are ignored.
The minimum interval that must transpire between two successive
Prunes sent by a router. This is used only with PIM-DM. Values may
range from 0 to 65535. The default value is 60.
Displays the time-interval a router waits for a Graft acknowledgment
before resending a Graft on the interface. This is only used with PIM-
DM. Values may range from 0 to 65535. The default value is 3.
Evaluates to TRUE if all routers on this interface are using the State
Refresh option. This is used only by PIM-DM.
The current operational status of the corresponding interface. Options
include enabled and disabled. This value indicates whether the IPv6
interface is operationally up. For example, if PIM is enabled on the
interface, but the interface is currently down, this field will display as
disabled. The default setting is disabled. To enable or disable
PIM on an interface, refer to the
page 23-89. To globally enable or disable PIM on the switch, refer to
the ipv6 pim sparse admin-state command on page 23-75
pim dense admin-state command on page
Enables IPv6 PIM and configures statistics such as hello-interval,
triggered-hello, hello-holdtime, joinprune, prune-delay, override-
interval, dr-priority, stub interface, prune limit interval, and graft
retry interval on the interface.
ipv6 pim interface command on
23-76.
OmniSwitch CLI Reference Guide
PIM Commands
and ipv6
March 2011