Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1452

show ip pim sparse
output definitions
Status
Keepalive Period
Max RPs
Probe Time
Register Checksum
Register Suppress Timeout
RP Threshold
SPT Status
Release History
Release 7.1.1; command was introduced.
page 23-38
The current global (i.e., switch-wide) status of PIM-SM. Options
include enabled and disabled.
The duration of the Keepalive timer. The default value is 210.
The maximum number of Rendezvous Points (RPs) allowed in the
PIM-SM domain (1–100). The default value is 32.
The amount of time before the Register Suppression timer expires, at
which point the Designated Router (DR) sends a Null Register message
to the Rendezvous Point (RP). This allows the RP to refresh the Regis-
ter-Stop. If the Register Suppression timer expires, the DR will resume
encapsulating packets from the source to the RP. Values may range
from 1 to 300. The default value is 5.
The current application of the checksum function on register messages
in the domain. Options include header and full. The default setting is
header.
The amount of time, in seconds, the Designated Router (DR) will stop
sending registers to the Rendezvous Point (RP) once a Register-Stop is
received (1–300). The default value is 60.
Displays the current RP data rate threshold. This value indicates the
rate, in bits per second (bps), at which the Rendezvous Point (RP) will
attempt to switch to native forwarding by issuing an (S, G) Join mes-
sage toward the source. Values may range from 0 to 2147483647. The
default value is 1. A value of 0 indicates that the feature is currently dis-
abled.
The current status of last hop Designated Router (DR) switching to the
Shortest Path Tree (SPT). Options include enabled and disabled.
The default setting is enabled.
OmniSwitch CLI Reference Guide
PIM Commands
March 2011