Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1444

ip pim interface
Defaults
parameter
hello-interval seconds
triggered-hello seconds
joinprune-interval seconds
hello-holdtime seconds
joinprune-holdtime seconds
prune-delay milliseconds
override-interval milliseconds
dr-priority priority
prune-limit-interval seconds
graft-retry-interval seconds
stub
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete a PIM interface.
•
PIM must be enabled globally on the switch before it runs on the interface. To globally enable or
disable PIM-SM on the switch, refer to the
enable or disable PIM-DM on the switch, refer to the
page 23-6.
•
Specifying zero for the hello-interval represents an infinite time, in which case periodic PIM Hello
messages are not sent.
•
Specifying zero for the joinprune-interval represents an infinite time, in which case periodic PIM Join/
Prune messages are not sent.
•
Specifying the value of 65535 for hello-holdtime represents an infinite time. If a PIM router gets Hello
packet from a neighbor with its hello-holdtime value as infinte time, then the PIM router will not time
out the sender(neighbor). It is recommended that you should use a hello-holdtime interval that is 3.5
times the value of the hello-interval, or 65535 seconds if the hello-interval is set to zero.
•
Specifying the value of 65535 for joinprune-holdtime represents an infinite time. The receipt of Join/
Prune messages with its joinprune-holdtime value as infinte time, then this specifies an infinite hold-
time for the particular join/prune message. It is recommended that you use a joinprune-holdtime inter-
val that is 3.5 times the value of the Join/Prune interval defined for the interface, or 65535 seconds if
the joinprune-interval is set to zero.
•
The interface configured as a stub will not send any PIM packets through that interface, and any
received PIM packets are also ignored. By default, a PIM interface is not set to be a stub one.
•
The graft-retry-interval and prune-limit-interval options can be used only with the PIM-DM mode.
page 23-30
default
30
5
60
105
210
500
2500
1
60
3
Disabled.
ip pim sparse admin-state command on page
ip pim dense admin-state command on
OmniSwitch CLI Reference Guide
PIM Commands
23-5. To
March 2011