Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1486

show ip pim sgroute
output definitions (continued)
Upstream Neighbor
UpTime
Flags
Pim Mode
Upstream Join State
Upstream Join Timer
RPF Next Hop
RPF Route Protocol
RPF Route Address/Prefix
Length
RPF Route Metric Pref
RPF Route Metric
DR Register State
DR Register Stop Timer
Upstream Prune State
Upstream Prune Limit Timer
Originator State
Source Active Timer
State Refresh Timer
Interface Name
Uptime
Local Membership
page 23-72
The primary address of the neighbor on the RPF Interface that the local
router is sending periodic (S,G) join messages to.
The time since this entry was created.
Flags indicating SPTBit, Prune State, Join State, etc.
Whether the Group Address is SSM, ASM or DM.
Whether the local router should join the SPT for the source and group
represented by this entry.
The time remaining before the local router next sends a periodic (S,G)
Join message.
The address of the RPF next hop towards the source.
The routing mechanism through which the route used to find the RPF
Interface towards the source was learned.
The IP address which when combined with the Route Prefix length
identifies the route used to find the RPF interface towards the source.
The metric preference of the route used to find the RPF interface
towards the source.
The metric preference of the route used to find the RPF interface
towards the source.
Whether the local router should encapsulate (S,G) data packets in Reg-
ister messages and send them to the RP. The possible values include
No Info, Join, Join Pending, or Prune.
The value of the Register Stop Timer. If the Register State is 'prune',
this is the time remaining before the local router sends a Null-Register
message to the RP. If the State is 'joinPending', this is the time remain-
ing before the local router resumes encapsulating data packets and
sending them to the RP.
Whether the local router has pruned itself from the tree. This is only
used by PIM-DM. The possible values include forwarding, Ack Pend-
ing, or Pruned.
The time remaining before the local router may send a (S,G) prune
message on alaPimSGRPFIfIndex. This is only used by PIM-DM.
Whether this router is an originator for the (S,G) message flow. This is
only used by PIM-DM. The possible values include Not Originator or
Originator.
If this router is the Originator, this is the time remaining before the local
router reverts to notOriginator state. Otherwise, this is zero. This is
only used by PIM-DM.
If Originator state is 'originator', this is the time remaining before the
local router sends a State Refresh Message. Otherwise, this is zero.
This is only used by PIM-DM.
The interface name corresponding to the ifIndex that corresponds to
this entry.
The time since this entry was created.
Whether the local router has (S,G) local membership on this interface.
OmniSwitch CLI Reference Guide
PIM Commands
March 2011