Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1537

PIM Commands
vlan-3
UpTime
Local Membership
Join/Prune State
RPT State
Prune Pending Timer
Join Expiry Timer
Assert State
Assert Timer
vlan-4
UpTime
Local Membership
Join/Prune State
RPT State
Prune Pending Timer
Join Expiry Timer
Assert State
Assert Timer
vlan-5
UpTime
Local Membership
Join/Prune State
RPT State
Prune Pending Timer
Join Expiry Timer
Assert State
Assert Timer
output definitions
Source-address
Group-address
RPF Interface
Upstream Neighbor
UpTime
Flags
Pim Mode
Upstream Join State
Upstream Join Timer
RPF Next Hop
RPF Route Protocol
RPF Route Address/Prefix
Length
RPF Route Metric Pref
OmniSwitch CLI Reference Guide
= 00h:01m:40s,
= False,
= No Info,
= No Info,
= 00h:00m:00s,
= 00h:00m:00s,
= No Info,
= 00h:00m:00s,
= 00h:00m:00s,
= False,
= No Info,
= No Info,
= 00h:00m:00s,
= 00h:00m:00s,
= No Info,
= 00h:00m:00s,
= 00h:00m:00s,
= False,
= No Info,
= No Info,
= 00h:00m:00s,
= 00h:00m:00s,
= No Info,
= 00h:00m:00s,
The IPv6 Source address.
The IPv6 Multicast Group Address.
The RPF interface towards the RP. The ifIndex is converted to the if-
name for the display.
The primary address of the neighbor on the RPF Interface that the local
router is sending periodic (S,G) join messages to.
The time since this entry was created.
Flags indicating SPTBit, Prune State, Join State, etc.
Whether the Group Address is SSM, ASM or DM.
Whether the local router should join the SPT for the source and group
represented by this entry.
The time remaining before the local router next sends a periodic (S,G)
Join message.
The address of the RPF next hop towards the source.
The routing mechanism through which the route used to find the RPF
Interface towards the source was learned.
The IP address which when combined with the Route Prefix length
identifies the route used to find the RPF interface towards the source.
The metric preference of the route used to find the RPF interface
towards the source.
March 2011
show ipv6 pim sgroute
page 23-123