Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1468

show ip pim interface
Stub Interface
Prune Limit Interval
Graft Retry Interval
State Refresh Enabled
Operational Status
output definitions
Interface Name
IP address
Designated Router
Hello Interval
Join/Prune Interval
Triggered Hello Interval
Hello Holdtime
Join/Prune Holdtime
Propagation Delay
Override Interval
Generation ID Option
DR Priority
Lan Delay Enabled
Effective Propagation Delay
page 23-54
= false,
= 60,
= 3,
= true,
= disabled
The name of the interface on which PIM is enabled.
Specifies the IP address of the specified interface.
The 32-bit IP address for the Designated Router (DR). The DR acts on
behalf of any directly-connected hosts with respect to the PIM-SM
protocol. Only one router in the LAN will act as the DR.
The frequency at which PIM Hello messages are transmitted on a spec-
ified interface. Values may range from 1 to 18000. The default value
is 30.
The Join/Prune interval for the associated interface. The Join/Prune
interval is the interval at which periodic PIM-SM Join/Prune messages
are sent. Values may range from 1 to 18000.
The current Triggered Hello Interval. This value indicates the maxi-
mum time, in seconds, before a triggered PIM Hello message is trans-
mitted on the corresponding interface. Values may range from 1 to 60.
The default value is 5.
The current Hello Holdtime value. This value indicates the maximum
amount of time, in seconds, Hello messages will be held before they are
considered invalid. Values may range from 0 to 65535. The default
value is 105.
The current Join/Prune Holdtime value. This value indicates the maxi-
mum amount of time, in seconds, Join/Prune messages will be held
before they are considered invalid. Values may range from 0 to 65535.
The default value is 210.
The expected propagation delay between PIM routers on this network.
The current Override Interval. This value is used to avoid synchroniza-
tion of override messages when multiple downstream routers share a
multi-access link. The sending of override messages is delayed at ran-
dom time intervals. The amount of randomization used by a router is
dictated by this number. Values may range from 0 to 65535. The
default value is 2500.
The value of the Generation ID this router inserted in the last PIM
Hello message it sent on this interface.
Displays the Designated Router priority for each interface. This value is
used in determining the Designated Router on an interface. Values may
range from 1 to 192. A higher numeric value denotes a higher priority.
Note that priority-based election is used only if all routers on the inter-
face are using the DR priority option. The default value is 1.
Options include true and false. The value will be true if all neighbors
on the interface are using the LAN Prune Delay option. Otherwise, the
setting will be false.
The Effective Propagation Delay on this interface.
OmniSwitch CLI Reference Guide
PIM Commands
March 2011