Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1469

PIM Commands
output definitions (continued)
Effective Override Interval
Suppression Enabled
DR Priority Enabled
Stub Interface
Prune Limit Interval
Graft Retry Interval
SR Priority Enabled
Operational Status
Release History
Release 7.1.1; command was introduced.
Related Commands
ip pim interface
MIB Objects
alaPimInterfaceTable
alaPimInterfaceIfIndex
alaPimInterfaceDR
alaPimInterfaceHelloInterval
alaPimInterfaceJoinPruneInterval
alaPimInterfaceStatus
alaPimInterfaceAddress
alaPimInterfaceTrigHelloInterval
alaPimInterfaceHelloHoldtime
alaPimInterfaceJoinPruneHoldtime
alaPimInterfacePropagationDelay
alaPimInterfaceOverrideInterval
alaPimInterfaceGenerationIDValue
alaPimInterfaceDRPriority
alaPimInterfaceLanDelayEnabled
alaPimInterfaceEffectPropagDelay
alaPimInterfaceEffectOverrideIvl
OmniSwitch CLI Reference Guide
The Effective Override Interval on this interface.
Specifies whether the Join suppression is enabled on this interface.
Evaluates to TRUE if all routers on this interface are using the DR Pri-
ority option.
Specifies whether this interface is a 'stub interface'. If this is TRUE,
then no PIM packets are sent out on this interface, and any received
PIM packets are ignored.
The minimum interval that must transpire between two successive
Prunes sent by a router. This is used only with PIM-DM.
Displays the time-interval a router waits for a Graft acknowledgment
before resending a Graft on the interface. This is used only with PIM-
DM. Values may range from 1 to 65535. The default value is 3.
Evaluates to TRUE if all routers on this interface are using the State
Refresh option. This is used only by PIM-DM.
The current operational status of the corresponding interface. Options
include enabled and disabled. This value indicates whether the IP
interface is operationally up. For example, if PIM is enabled on the
interface, but the IP interface is currently down, this field will display
as disabled. The default setting is disabled. To globally enable or dis-
able PIM on the switch, refer to the
mand on page 23-5
page 23-6.
Enables or disables the PIM protocol on a specific interface.
March 2011
ip pim sparse admin-state com-
and ip pim dense admin-state command on
show ip pim interface
page 23-55