Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual page 1197

BGP Commands
output definitions (continued)
Neighbor route-reflector-client Indicates whether this peer is a client to the local route reflector, if
Neighbor confederation status Indicates whether this peer is a member of a BGP confederation.
Neighbor remove private AS
Neighbor default originate
Neighbor maximum prefixes
Neighbor max prefixes
warning
# of prefixes received
Neighbor MD5 key
Neighbor local port
Neighbor TCP window size
Graceful Restart State
Advertised Restart Interval
Forwarding State during
restart
Activate IPv6 unicast
Configured IPv4 NextHop
Address
Configured IPv6 NextHop
Address
Neighbor Ipv6 unicast
Release History
Release 7.1.1; command was introduced.
OmniSwitch CLI Reference Guide
configured.
Indicates whether the stripping of private AS numbers (64512 to
65535) from AS paths is enabled or disabled.
Indicates whether peer default origination is enabled or disabled.
When enabled, the local BGP speaker advertises the default route to
the peer. This value is configured through the
default-originate
The maximum number of prefixes the local router can receive in
UPDATE from this peer. This value is configured through the
bgp neighbor maximum-prefix
Indicates whether a warning will be issued when this peer exceeds 80
percent of the maximum prefix value. This value is configured through
the ipv6 bgp neighbor update-source
Displays the total number of prefixes received by this neighbor.
When present, shows an encrypted version of the MD5 password.
When not present, and MD5 password has not been configured.
The TCP port used for the session with this peer.
The size of the TCP window for this BGP session. This value will
always be 32768 as that is the maximum size of a BGP message.
Indicates the graceful restart state. This feature does not support IPv6
prefixes.
Indicates the restart interval in seconds.
Indicates whether the peer has preserved the forwarding state
during the graceful restart.
Indicates whether or not IPv6 unicast advertisements are enabled.
Options include enabled or disabled.
Specifies the IPv4 nexthop address. This is specified using the
bgp neighbor ipv4-nexthop
Specifies the IPv6 nexthop address. This is specified using the
bgp neighbor ipv6-nexthop
Indicates whether or not IPv6 unicast capability is advertised
between the peers. Options include
March 2011
command.
command.
command.
command.
command.
enabled
show ipv6 bgp neighbors
ipv6 bgp neighbor
ipv6
ipv6
ipv6
or .
disabled
page 19-229