[:Level][:Immediate] [:Amplitude]:Unit [:Voltage]; Unit; [:Voltage] - HP E1340A User Manual

[:LEVel][:IMMediate]
[:AMPLitude]:UNIT

[:VOLTage]

Parameters
Comments
Example
Chapter 7
[SOURce:]VOLTage[:LEVel][:IMMediate] [:AMPLitude]:UNIT [:VOLTage]
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude]:UNIT[:VOLTage]
units sets the default units for subsequent
< >
SOURce:VOLTage:LEVel:IMMediate:AMPLitude
The available default units are:
DBM|DBMW:
V: Volts. This is equivalent to VPK for time-varying waveforms.
Volts peak
VPK:
VPP: Volts peak-to-peak
Volts RMS
VRMS:
W: Watts
For , , and
W DBM
OUTPut:LOAD
unavailable if
meaningless and unavailable for user-defined waveforms
(
SOURce:FUNCtion:USER
from the VXIbus (
Parameter Parameter
Name Type
units discrete
Related Commands:
SOURce:VOLTage:LEVEL:IMMediate:AMPLitude
Executable when initiated: Yes
Coupled command: No
*RST Condition:
SOURce:VOLTage:LEVel:IMMediate:AMPLitude:UNIT:VOLTage V
Setting the default voltage units
VOLT:UNIT:VOLT VPP
dB referenced to 1 milliwatt.
, the amplitude is referenced to the
DBMW
value; they are meaningless and therefore
OUTPut:LOAD INFinity is set. These units are also
set) and when directly driving the DAC
SOURce:ARBitrary:DAC:SOURce VXI
Range of
Values
DBM | DBMW | V | VPK
VPP | VRMS | W
,
OUTPut:LOAD
Set default units to volts
peak-to-peak
HP E1340A Command Reference
commands.
set).
Default
Units
none
179