[Source:]Marker; Feed; Source; Marker - HP E1340A User Manual

[SOURce:]MARKer

Subsystem Syntax

:FEED

Parameters
Comments
Example
Chapter 7
The [SOURce:]MARKer
Which signal is routed to the "Aux Out" BNC.
The polarity of the "Aux Out" BNC signal.

[SOURce:]

MARKer

:FEED <
:POLarity <
[SOURce:]MARKer:FEED <
"Aux Out" BNC. The available sources are:
"OUTPut:ZERO":
crosses through zero.
INVerted
"SEGMent":
that multiple segment waveforms like AB or ABCD will have 2 and
4 marker pulses per cycle respectively.
must be set to
"[SOURce:]ROSCillator":
reference oscillator.
NORMal
"[SOURce:]SWEEP":
frequency sweep.
NORMal
Parameter Parameter
Name Type
source
string
Executable when initiated: Query form only
Coupled command: Yes
Related Commands: SOURce:MARKer:POLarity
*RST Condition: SOURce:MARKer:FEED "SEGMent"
Setting the "Aux Out" BNC source
MARK:FEED "SOUR:ROSC"
subsystem controls:
source
>
polarity
>
source > selects the source for the front panel
Outputs marker pulses whenever the waveform
SOURce:MARKer:POLarity
when using this source.
Outputs a pulse at the completion of a segment. Note
when using this source.
NORMal
The internal 42.94967296 MHz
SOURce:MARKer:POLarity
when using this source.
Outputs a marker pulse on the last point of a
SOURce:MARKer:POLarity
or INVerted with this source.
Range of
Values
"OUTPut:ZERO" |
"SEGMent" |
"[SOURce:]ROSCillator" |
"[SOURce:]SWEep"
HP E1340A Command Reference
[SOURce:]MARKer:FEED
must be set to
SOURce:MARKer:POLarity
must be set to
may be either
Default
Units
none
Set marker reference oscillator as
source
167