Sre And *Sre; Stb - HP E1340A User Manual

Parameters
Comments

*SRE and *SRE?

Parameters
Comments
Example

*STB?

Comments
Chapter 7
Parameter Parameter
Name Type
number numeric
Executable when initiated: No
Coupled command: No
Related Commands:
*RST Condition: all saved states set to the same state as the
state
*SRE < mask > specifies which bits of the Status Byte Register are enabled
to generate a IEEE-488.1 service request. Event and summary bits are
always set and cleared in the Status Byte Register regardless of the enable
mask. Mask is the sum of the decimal weights of the bits to be enabled.
The query form returns the current enable mask.
Parameter Parameter
Name Type
mask numeric
A 1 in a bit position enables service request generation when the
corresponding Status Byte Register bit is set; a 0 disables it.
Executable when initiated: Yes
Coupled command: No
*RST Condition: unaffected
Power-On Condition: no bits are enabled
Enable service request on Message Available bit
*SRE 16
returns the value of the Status Byte Register. Bit 6 (decimal weight 64)
*STB?
is set if a service request is pending.
Executable when initiated: Yes
Coupled command: No
Related commands:
*RST Condition: none
Range of
Values
0 through 9
*LRN? , *RCL , *RST
Range of
Values
0 through 255
Enable request on MAV
*SRE
HP E1340A Command Reference
*SRE and *SRE?
Default
Units
none
*RST
Default
Units
none
195