HP E1340A User Manual page 176

[SOURce:]SWEep:TIME
Comments
Example
176 HP E1340A Command Reference
The last frequency point is output for the same length of time as all
other points. The
each sweep until the last frequency begins to be output and does not
include the time for the last frequency point. Therefore, if a specific
sweep repetition time is desired,
according to the following equation:
SWEep:TIME =
Thus, to set a repetition time of 1 S for a 100 point sweep,
SWEep:TIME should be set to .99 S.
Executable when initiated: Query form only
Coupled command: Yes
Related Commands:
*RST Condition:
Setting the duration of the sweep
SWE:TIME 20
SWEep:TIME value is the time from the start of
SWEep:TIME
time points points
* ( - 1) /
SOURce:SWEep:POINts, CAL:STATe:AC
SOURce:SWEep:TIME 1.05
Set sweep to take 20 seconds
should be set
Chapter 7