Load - HP E1340A User Manual

OUTPut:LOAD

:LOAD

Parameters
Comments
Example
148 HP E1340A Command Reference
OUTPut:LOAD < load
E1340A's "Aux Out" BNC is either matched to the output impedance
specified by
OUTPut:IMPedance
into an open circuit is twice that into a matched load. Setting
OUTPut:LOAD INFinity
SOURce:LIST:SEGMent:VOLTage
SOURce:VOLTage:LEVel:IMMediate:AMPLitude
will output the specified voltages into an open circuit.
Parameter Parameter
Name Type
load numeric
MINimum and MAXimum both select 50
Use 9.9E+37 or INFinity to indicate an open circuit output.
Executable when initiated: Query form only
Coupled command: Yes
Related commands:
subsystem, SOURce:VOLTage
*RST Condition:
Indicating open circuit output load
OUTP:LOAD INF
> indicates whether the actual load applied to the HP
or is an open circuit. The output voltage
compensates for this effect so that the
and
Range of
Values
50 |
9.9E+37 | INFinity |
MINimum | MAXimum
load impedance.
OUTPut:IMPedance
subsystem
OUTPut:LOAD 50
Indicate open circuit
and commands
OFFSet
Default
Units
Ohms
,
SOURce:LIST
Chapter 7