Points; Time - HP E1340A User Manual

:POINts

Parameters
Comments
Example

:TIME

Parameters
Chapter 7
[SOURce:]SWEep:POINts <
frequency sweep.
The frequencies generated by the sweep are evenly spaced linearly between
the frequencies specified by
CENTer and SPAN , inclusive.
Parameter Parameter
Name Type
number numeric
The legal range for number
context-dependent. See the section "Sweep Considerations" at the beginning
of the SOURce:SWEep subsystem for a description of the dependencies.
Executable when initiated: Query form only
Coupled command: Yes
Related Commands:
SPAN , START
*RST Condition:
Setting the number of points in the sweep
SWE:POIN 100
[SOURce:]SWEep:TIME <
duration is the time from the start of the sweep until when the last frequency
begins to be output.
Parameter Parameter
Name Type

time

numeric
With CALibration:STATe:AC OFF set: MINimum selects 0.187 mS *
(

points

- 1); MAXimum selects 25.687 mS * (
With CALibration:STATe:AC ON set: MINimum selects 0.250 mS *
( points - 1); MAXimum selects 25.75 mS * (
points is specified by the SOURce:SWEep:POINts command.
The above values bound the valid range for
number > selects the number of points in a
SOURce:FREQuency:STARt
Range of
Values
see below |
MINimum | MAXimum
, as well as the MINimum and MAXimum values, is
SOURce:FREQuency:CENTer
, and STOP
SOURce:SWEep:POINts 1001
Set 100 points in sweep
time > selects the duration of the sweep. The
Range of
Values
see below |
MINimum | MAXimum
points
points - 1).
time
.
HP E1340A Command Reference
[SOURce:]SWEep:POINts
and STOP , or
Default
Units
none
, ,
MODE
Default
Units
seconds
- 1).
175