[:Start]:Layer2 :Count; [:Start]:Layer2 :Slope - HP E1340A User Manual

ARM[:STARt]:LAYer2 :COUNt
[:STARt]:LAYer2
:COUNt
Parameters
Comments
Example
[:STARt]:LAYer2
:SLOPe
Parameters
Comments
Example
140 HP E1340A Command Reference
ARM[:STARt]:LAYer2:COUNt <
waveform start arms the HP E1340A will accept after an
command before returning the trigger system to the idle state.
Parameter Parameter
Name Type
number
numeric
MINimum and MAXimum select 1 arm.
9.9E+37 is equivalent to INFinity.
If ARM:STARt:LAYer2:COUNt 1
ARM:STARt:LAYer2:SOURce
ARM:STARt:LAYer2:COUNt INFinity
ARM:STARt:LAYer2:SOURce
Executable when initiated: Query form only
Coupled command: Yes
Related Commands:
ARM:STARt:LAYer2:SOURce
*RST Condition:
Setting the start arm count
ARM:LAY2:COUN INF;SOUR EXT
ARM[:STARt]:LAYer2:SLOPe <
on the HP E1340A's front panel "Aux In" BNC which starts waveform
generation. This edge is significant only with
ARM:STARt:LAYer2:SOURce
retained but not used when other sources are selected.
Parameter Parameter
Name Type
edge discrete
Executable when initiated: Query form only
Coupled command: Yes
Related Commands:
*RST Condition:
Setting the start arm slope
ARM:LAY2:SLOP NEG
number > specifies the number of
Range of
Values
1 | 9.9e37 | INFinity|
MINimum | MAXimum
is set, then
must be set to
is set,
must be set to
ABORt, INITiate:IMMediate,
ARM:STARt:LAYer2:COUNt 1
Start arm count is infinity, and
source is front panel "Aux In" BNC
edge selects the edge (rising or falling)
>
set to . The programmed value is
EXTernal
Range of
Values
NEGative | POSitive
ARM:STARt:LAYer2:SOURce
ARM:STARt:LAYer2:SLOPe POSitive
Set negative start arm slope
INITiate:IMMediate
Default
Units
none
. If
IMMediate
.
EXTernal
Default
Units
none
Chapter 7