CALibration:AC:BEGin
CALibration
Subsystem Syntax
:AC:BEGin
Comments
142
HP E1340A Command Reference
The
CALibration
subsystem has commands that calibrates the HP E1340A.
The subsystem also includes commands to prevent and detect accidental or
unauthorized calibration of the HP E1340A.
CALibration
:AC
:BEGin
value
:POINt? <
:DATA
:AC <
block
>
block
[:DC] <
>
[:DC]
:BEGin
value
:POINt? <
:STATe
:AC <
state
>
CALibration:AC:BEGin
E1340A. It sets the HP E1340A up for the first of the measurements in the
procedure. See the " Calibration" section of the HP E1340A Service
Manual for detailed information on the use of this command.
Most of the HP E1340A's commands cannot be executed while
calibration is in progress. The
prematurely terminate the calibration procedure without affecting the
stored calibration constants.
Executable when initiated: No
Coupled command: No
Related commands:
*RST Condition: none
[no query]
>
[query only]
[no query]
>
[query only]
starts the AC calibration procedure for the HP
*RST
command may be used to
CALibration:AC:POINt
Chapter 7