OUTPut
Subsystem Syntax
:IMPedance
Parameters
Comments
Example
Chapter 7
The
OUTPut
subsystem controls the characteristics of the output waveform.
The subsystem sets the output source impedance, and enables or disables
the output.
OUTPut
:IMPedance <
load
:LOAD <
>
OUTPut:IMPedance <
impedance.
Since the HP E1340A only provides 50 output impedance, there is no
need to send this command. It is provided for SCPI compatibility only.
Parameter
Parameter
Name
Type
impedance
numeric
MINimum and MAXimum select 50 output impedance.
Impedance values between 25 and 62.5 will be accepted and rounded
to 50 . Values outside that range will cause error -222,"Argument
out of range" to occur.
Executable when initiated: Yes
Coupled command: Yes
Related commands:
*RST Condition:
Querying output impedance
OUTP:IMP?
impedance
>
impedance
>
sets the HP E1340A's output
Range of
Values
50
MINimum | MAXimum
OUTPut:LOAD
OUTPut:IMPedance 50
50 will be returned with this query
HP E1340A Command Reference
OUTPut:IMPedance
Default
Units
Ohms
147