Eeprom Writing - Panasonic MINAS A5-series Operating Instructions Manual

2
Preparation
Parameter Setup Mode SELECTION display

EEPROM Writing

SELECTION display
• To write the parameter to EEPROM, press
to change to EXECUTION display.
SELECTION display
Auxiliary Function Mode
Caution
1. When writing error occurs, make writing again. If the writing error repeats many times,
this might be a failure.
2. Don't turn off the power during EEPROM writing. Incorrect data might be written. If this
happens, set up all of parameters again, and re-write after checking the data.
3. When the error defined by Err.11.0 "Under voltage protection of control power supply"
occurs,
15. How to Use the Front Panel
EEPROM Writing
(Mode switch button)
(SET button)
(Mode switch button)
is displayed indicating that no writing is made to EEPROM.
EXECUTION display
• Keep pressing until the display
changes to
execute writing.
* "Start" flashes instantaneously and is
difficult to check visually.
" " increases while
keep pressing
approx. 5sec) as the
right fig. shows.
Starts writing.
Writing completes
Note
When you change the parameters which
contents become valid after resetting,
will be displayed after finishing
wiring. Turn off the control power once to
reset.
when you
(for
Writing error
2-73
1
2
3
4
5
6
7