Parameter Setup Mode - Panasonic MINAS A5-series Operating Instructions Manual

2
Preparation
Monitor Mode

Parameter Setup Mode

Parameter No.
(Hexadecimal No.)
Class
Note
For parameters which place is displayed
with " ", the content changed and
written to EEPROM becomes valid after
turning off the power once.
• Press or
to be set.
• Press and the flashing decimal
separator shifts to the high order position,
allowing the figure at this digit to any other
figure.
• Display the No. of parameter to be
changed and press
EXECUTION display.
EEPROM Writing
Note
• After setting up parameters, return to SELECT mode, referring to structure of each mode
(P.2-54).
• Each parameter has a limit in number of places for upper-shifting.
2-72
15. How to Use the Front Panel
Parameter Setup Mode
SELECTION display
(Mode switch button)
SELECTION display
to select parameter No.
Pr0.00
Pr0.01
Pr6.22
Pr6.33
Pr0.00
Pr0.01
Pr0.11
Pr1.11
to change to
(Mode switch button)
SELECTION display
EXECUTION display
Parameter value
• Press or
parameter. (Value increases with
decreases with
• Press and the flashing decimal
separator shifts to the high order position,
allowing the figure at this digit to any other
figure.
• Prolonged depression of
parameter in the driver. Note that the
parameter value selected by
not reflected until
way.
• To cancel the value selected by
press instead of
(SET button)
internal parameter value is kept
unchanged and the display returns to the
parameter number display screen.
Remarks
After changing the parameter value and
pressing , the content will be reflected in
the control. Do not extremely change the
parameter value which change might affect the
motor movement very much (especially
velocity loop or position loop gains).
You can change the
value which digit has
a flashing decimal
point.
to set up the value of
.)
updates the
or is
is pressed in this
or
, and the driver
,