Configuring the Director
Configuring Fabric Parameters
Use procedures in this section to set parameters on the director for fabric
operation through the Configure Fabric Parameters dialog box. These
parameters are stored in NV-RAM on the director.
1. Verify that the director is set offline. For instructions, refer to the
2. Choose Configure > Operating Parameters > Fabric Parameters from the
Figure 34: Configure Fabric Parameters dialog box
3. Use information under
4. After you change settings, click Activate.
5. Back up the configuration data when you are finished configuring the
6. Set the director online. For instructions, see
124
Director Online
State" on page 81.
Caution:
Setting the director offline terminates all Fibre Channel connections.
Product Manager window. The Configure Fabric Parameters dialog box
displays, as shown in
parameters in this dialog box.
director.
on page 81.
Figure
34.
"Fabric
Parameters" to change settings as required for
"Setting Director Online
Director Product Manager User Guide
"Setting
State"