Configuring Switch Parameters
Use the procedures in this section to set parameters on the director for fabric
operation through the Configure Switch Parameters dialog box. These
parameters are stored in NV-RAM on the director.
1. The director must be offline to change Preferred Domain ID and
2. Choose Configure > Operating Parameters > Switch Parameters. The
Figure 32: Configure Switch Parameters dialog box (Director 2/64)
Figure 33: Configure Switch Parameters dialog box (Director 2/140)
Director Product Manager User Guide
Management Style parameters. Verify that the director is set offline. For
instructions, refer to the
Caution:
Setting the director offline terminates all Fibre Channel connections.
Configure Switch Parameters dialog box displays.
switch parameters for the Director 2/64 and
parameters for the Director 2/140.
"Setting Director Online
Figure 33
Configuring the Director
State" on page 13.
Figure 32
displays the
displays the switch
119