HP Surestore 64 - Director Switch User Manual page 220

Information and Error Messages
Table 9: Product Manager Messages (Continued)
Invalid network
address.
Invalid port address.
Invalid port number.
Invalid port number.
Valid ports are (0-63).
Invalid port number.
Valid ports are (0-127,
132-143).
Invalid port swap.
Invalid response
received from director.
220
Message
The IP address
specified for the
product is unknown to
the domain name
server (invalid).
Invalid port address
has been entered.
The port number must
be within a range of
ports for the specific
director model
Director 2/64 only.
The Fibre Channel
number entered is
invalid. The port
number must be an
integer from 0 through
63 inclusive.
Director 2/140 only.
Port number must be
within the range of
ports for the specific
director model. For this
model, the valid port
numbers are 0-127
and 132-143. Ports
128-131 are not valid
because they are
internal ports and
cannot be connected
to external fiber optic
cables.
Port swap selection is
not allowed.
An error occurred at
the director during a
firmware download
operation.
Description
Verify and enter a valid product
IP address.
Verify port address through the
Configure Addresses - "Active"
dialog box (FICON
management style only) and
re-enter.
Enter a port number within the
correct range.
Verify and enter a valid port
number.
Enter a port number within the
correct range.
Ensure that each port selected
for swap has not been
previously swapped.
Retry the firmware download
operation. If the problem
persists, contact the next level of
support.
Director Product Manager User Guide
Action