HP Surestore 64 - Director Switch User Manual page 227

Table 9: Product Manager Messages (Continued)
Switch Binding was
removed from attached
devices that are also
participating in Port
Binding. Please review
the Port Binding
Configuration.
System diagnostics
cannot run. The
Operational Status is
invalid.
The add firmware
process has been
aborted.
The data collection
process failed.
The data collection
process has been
aborted.
The default zone must
be disabled to
configure.
The switch did not
accept the request.
The switch did not
respond in the time
allowed.
Director Product Manager User Guide
Message
The device WWNs
were removed from the
director's Switch
Membership List
(SANtegrity Binding
feature), but you
should note that one or
more of these devices
still has security control
in port binding.
System diagnostics
cannot run on switches
with failed ports
The user aborted the
process to add a
firmware version to the
HAFM Server's
firmware library.
An error occurred
while performing the
data collection
procedure.
The user aborted the
data collection
procedure.
The message displays
when the user attempts
to change the
management style to
Open Fabric and the
default zone is
enabled.
The director or switch
cannot perform the
requested action.
While waiting to
perform a requested
action, the director or
switch timed out.
Description
Verify that the security level for
each device is as required by
reviewing the Bound WWN list
in the Configure Ports dialog
box.
Replace failed ports.
Verify the firmware addition is
to be aborted, then click OK to
continue.
Try the data collection
procedure again. If the problem
persists, contact the next level of
support.
Verify the data collection
procedure is to be aborted,
then click OK to continue.
Disable the default zone and
repeat the operation.
Retry the operation. If the
condition persists, contact the
next level of support.
Retry the operation. If the
condition persists, contact the
next level of support.
Information and Error Messages
Action
227