HP Surestore 64 - Director Switch User Manual page 207

Table 9: Product Manager Messages (Continued)
Are you sure you want
to delete this address
configuration?
Are you sure you want
to send firmware
version?
Cannot change Port
Type while
Management Style is
FICON without
SANtegrity feature.
Please contact your
sales representative.
Cannot disable Switch
Binding while
Enterprise Fabric Mode
is active and the switch
is Online.
Cannot disable
Insistent Domain ID
while Fabric Binding is
active.
Cannot enable
beaconing on a failed
FRU.
Cannot enable
beaconing while the
system light is on.
Director Product Manager User Guide
Message
Confirmation to delete
the selected address
configuration.
This message requests
confirmation to send a
firmware version from
the HAFM server's
firmware library to the
director. Firmware
library can store up to
8 firmware versions.
Firmware is below the
required level and user
attempted to change a
port type in the
Configure Ports dialog
box while FICON
management style, but
the optional
SANtegrity Binding
feature is not installed.
User attempted to
disable Switch Binding
through the Switch
Binding Change State
dialog box, but
Enterprise Fabric Mode
is enabled.
User attempted to
disable the Insistent
Domain ID parameter
through the Configure
Switch Parameters
dialog box, but Fabric
Binding is enabled.
Occurs when selecting
Enable Beaconing
option for a failed
FRU.
Occurs when choosing
Enable Beaconing
option for a failed
FRU.
Description
Click Yes to confirm the deletion
of the address configuration or
No to cancel the operation.
Click Yes to send the firmware
version or No to abort the
operation.
Informational message. If the
firmware is below the required
level, install SANtegrity Binding
before changing port types in
the Configure Ports dialog box
while in FICON management
style.
You must either disable
Enterprise Fabric Mode using
the Enterprise Fabric Mode
dialog box in the
application or set the switch
offline before you can disable
Switch Binding.
Disable Fabric Binding through
the Fabric Binding dialog box
before disabling these
parameters.
Replace FRU and enable
beaconing again or enable
beaconing on operating FRU.
Replace FRU and enable
beaconing again or enable
beaconing on an operating
FRU.
Information and Error Messages
Action
HAFM
207