Using The Port Card View; Symbols And Indicators; Port Card View - HP Surestore 64 - Director Switch User Manual

Monitoring and Managing the Director
Note:

Using the Port Card View

In the Hardware View, double-click a port card or right-click and choose Open
Port Card View to see a detailed view of the port card. In the Port Card View,
colored indicators reflect functions of the actual LEDs on the card. The table in
the Port Card View displays the port operating state and vital product
information.

Symbols and Indicators

The following figure illustrates the status symbols and LED indicators that may
display on a port card in the Port Card View.
UPM
Figure 22: Port Card View
84
If you click the Enable Beaconing check box to add a check mark, the amber
LED beacons (blinks) on the card that was the active card before switchover.
You must have maintenance authorization rights to access this feature.
1
2
3
An amber LED (at the top of the card) that illuminates if
1
any port fails or blinks if FRU beaconing is enabled.
A bank of amber and green LEDs above the ports. One
2
amber LED and one green LED are associated with
each port and indicate port status as follows:
The green LED illuminates (or blinks if there is active
traffic) and the amber LED extinguishes to indicate
normal port operation.
The amber LED illuminates and the green LED
extinguishes to indicate a port failure.
Both LEDs extinguish to indicate a port is
operational but not communicating with an N_Port
(no cable attached, loss of light, port blocked, or
link recovery in process).
The amber LED flashes and the green LED either
remains on, extinguishes, or flashes to indicate a
port is beaconing or running online diagnostics.
Four duplex LC connectors for attaching fiber optic
3
cables.
Director Product Manager User Guide