Configure Menu - HP Surestore 64 - Director Switch User Manual

Configure Menu

Click the Configure menu on the menu bar to display a menu that lists the
following options. For detailed information on using these dialog boxes, refer to
Chapter
Note:
Hardware View and in the
configured to display names.
Director Product Manager User Guide
3, "Configuring the
Identification—Choose this option to display the Configure Identification
dialog box. Enter the following information in this dialog box:
— Name—Assign a product name. Note that you can set this name as the
nickname for the director's WWN, using the Set Name As Nickname
check box. The nickname then displays instead of the WWN in Product
Manager views.
— Description—Assign a unique product description.
— Location—Describe the product's location.
— Contact—Assign a contact either by name, phone number, or e-mail
address.
This information displays in the identification table at the top of the
Switch Operating Parameters—Choose this option to display the
Configure Switch Parameters dialog box for setting Fibre Channel
operating parameters. In this dialog box, you can set the preferred domain
identification (1 to 31), and also make it insistent if SANtegrity Binding
feature is installed. You can also enable rerouting delay, and domain register
for state change notifications (RSCNs). In addition, you can also set the
director data speed (Director 2/64 only). The director must be offline to
configure director speed and preferred domain ID.
Fabric Operating Parameters—Choose this option to display the Configure
Fabric Parameters dialog box for setting fabric operating parameters. In this
dialog box, you can set buffer-to-buffer credit (BB_Credit) from 1 to 60
(default is 16) and the resource allocation time-out value (R_A_TOV) and
error detect time-out value (E_D_TOV) in tenth-of-a-second increments. In
addition, you can set the switch priority level (Principal, Default, or Never
Principal) and the interoperability modes between Homogeneous, and Open
Fabric 1.0. Refer to
information on configuring these parameters for the director. The director
must be offline to configure any fabric operating parameter.
Director."
HAFM
application Product View, if the Product View is
"Configuring Fabric
Product Manager Overview
Parameters" on page 124 for more
39