Data Default Values - HP Surestore 64 - Director Switch User Manual

Note:
was shipped from the factory, these features will be disabled (factory default) when the
configuration is reset. Only those ports that were enabled at the factory will function.
You will have to enable the additional port function features again through the
Configure Feature Key dialog box.
Factory-default values may vary, depending on the firmware release installed in
your director. For a list of values, refer to the HP StorageWorks Director 2/64
Service Manual for the Director 2/64 and the HP StorageWorks Director 2/140
Service Manual for the Director 2/140.
Table 7: Data Default Values
Configuration
Identification
Ports
Director
Addressing
Director Product Manager User Guide
If you have enabled features that add additional port function since the director
Description
Director Name
Director Description
Director Contact
Director Location
Port Names
Port Blocked States
Extended Distance
(10-100km)
LIN Alerts
Port Address
IP Address
Subnet Mask
Gateway Address
MAC Address
Using Maintenance Features
Default
NULL string
"Fibre Channel Director"
"End User Contact (please
configure)"
"End User Contact (please
configure)"
NULL strings
Unblocked
Disabled
Disabled
Port number plus 4
10, mac[3], mac[4], mac[5]
converted to word32
MAC addresses are set in
hexadecimal; IP addresses in
decimal. A MAC address of 08
00 88 20 00 57 will be reset to
an IP address of 10.32.0.87.
255.0.0.0
0.0.0.0
PROM value
183