Opening The Bezel Media Door - Lenovo ThinkServer TD200x Hardware Maintenance Manual

1
Bezel
2
Hinge assembly
3
Retention tabs
To install the bezel, do the following:
1. Align the hinge assemblies with the hinge holes on the chassis.
2. Push the hinges into the holes on the chassis until they snap into place.
3. If however, the bezel was removed by detaching the sliding hinge mount from the hinge assembly (using
the breakaway method as the bezel was designed to do), complete the following steps to reattach
the bezel:
a. Press in on the rear of the sliding hinge mount until it extends beyond the edge of the bezel and
hold it in place.
b. Align the sliding hinge mount
c. Press the sliding hinge mount against the hinge pin until the sliding hinge mount snaps onto the
hinge pin.
4. Close the bezel (see Closing the bezel).
5. Lock the left-side cover.

Opening the bezel media door

To open or remove the media door, do the following:
1. Read the safety information that begins on page Safety information.
2. Unlock the side cover.
Note: You must unlock the side cover to open or remove the bezel. When you lock the server side
cover, it locks both the cover and the bezel.
3. Grasp the depressed area on the left side of the bezel door and rotate the bezel to the open position.
4. From inside of the top section of the bezel door, slide the blue tab up to unlock the bezel media door;
then, grasp the depressed area on the left side of the media door and pull the door open.
150
ThinkServer TD200x Hardware Maintenance Manual
1 2
with the hinge pin on the hinge assembly
3
on the chassis.