Lenovo ThinkServer TD200x Hardware Maintenance Manual page 197

0
Bay 0
1
Bay 1
2
Bay 2
3
Bay 3
4
Bay 4
5
Bay 5
6
Bay 6
7
Bay 7
• For a list of supported optional devices for the server, see http://www.lenovo.com/thinkserver.
• Inspect the drive and drive bay for signs of damage.
• Make sure that the drive is correctly installed in the drive bay.
• See the documentation for the ServeRAID controller for instructions for installing a hard disk drive.
• All hot-swap drives in the server must have the same throughput speed rating; using drives with different
speed ratings might cause all drives to operate at the throughput of the slowest drive.
• You do not have to turn off the server to install hot-swap drives in the hot-swap drive bays. However, you
must turn off the server when you perform any steps that involve installing or removing cables.
• The drive ID for each hot-swap hard disk drive is printed above the drive bay.
1
Filler panel
2
Hard disk drive assembly
3
Release latch
4
Drive handle
To install a hot-swap hard disk drive, do the following:
1. Read the safety information that begins on page Safety information.
8
9
10
11
12
13
14
15
.
Chapter 7 Installing optional devices and replacing customer replaceable units
Bay 8
Bay 9
Bay 10
Bay 11
Bay 12
Bay 13
Bay 14
Bay 15
189