Installing A 2.5-Inch Hot-Swap Hard Disk Drive - Lenovo ThinkServer TD200x Hardware Maintenance Manual

3
Release latch
4
Drive handle
To remove a hot-swap hard disk drive, do the following:
1. Read the safety information that begins on page Safety information.
Attention: Static electricity that is released to internal server components when the server is powered
on might cause the server to halt, which might result in the loss of data. To avoid this potential problem,
always use an electrostatic-discharge wrist strap or other grounding system when you work inside
the server with the power on.
2. Open the bezel (see "Opening the bezel" on page 146).
3. Press down on the release latch to open the drive handle; then, pull the drive out of the drive bay.
4. If you are instructed to return the hot-swap hard disk drive, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.

Installing a 2.5-inch hot-swap hard disk drive

The following notes describe the types of hard disk drives that the server supports and other information that
you must consider when you install a hard disk drive:
• Depending on the model, the server supports up to eight or up to 16 2.5-inch SAS hot-swap hard disk
drives in the hot-swap bays.
• The hot-swap bays are arranged horizontally in the top and bottom hard disk drive cages:
– On models with eight hard disk drives, the top bays are numbered 0 through 7 (from right to left)
– On models with 16 hard disk drives, the top bays are numbered 0 through 7 (from right to left) and the
bottom bays are 8 through 15 (from right to left)
188
ThinkServer TD200x Hardware Maintenance Manual