Lenovo ThinkServer TD200x Hardware Maintenance Manual page 250

• Start Options
Select this choice to view or boot to devices, including the startup sequence. The server starts from the
first boot record that it finds.
This choice is on the full Setup Utility menu only.
• Boot Manager
Select this choice to view, add, delete, or change the device boot priority, boot from a file, select a
one-time boot, or reset the boot order to the default setting.
• System Event Logs
Select this choice to enter the System Event Manager, where you can view the error messages in the
system event logs. You can use the arrow keys to move between pages in the error log.
The system event logs contain all event and error messages that have been generated during POST, by
the systems-management interface handler, and by the system service processor. Run the diagnostic
programs to get more information about error codes that occur. See Chapter 5 "Diagnostics" on page 21
for instructions for running the diagnostic programs.
Important: If the system-error LED on the front of the server is lit but there are no other error indications,
clear the IMM system-event log. Also, after you complete a repair or correct an error, clear the IMM
system-event log to turn off the system-error LED on the front of the server.
– POST Event Viewer
Select this choice to enter the POST event viewer to view the POST error messages.
– System Event Log
Select this choice to view the IMM system event log.
– Clear System Event Log
Select this choice to clear the IMM system event log.
• User Security
Select this choice to set, change, or clear passwords. See "Passwords" on page 243 for more information.
This choice is on the full and limited Setup Utility menu.
– Set Power-on Password
Select this choice to set or change a power-on password. See "Power-on password" on page 243
for more information.
– Clear Power-on Password
Select this choice to clear a power-on password. See "Power-on password" on page 243 for more
information.
– Set Administrator Password
Select this choice to set or change an administrator password. An administrator password is intended
to be used by a system administrator; it limits access to the full Setup Utility menu. If an administrator
password is set, the full Setup Utility menu is available only if you type the administrator password at
the password prompt. For more information, see "Power-on password" on page 243.
– Clear Administrator PasswordSelect this choice to clear an administrator password. For more
information, see "Passwords" on page 243s.
• Save Settings
Select this choice to save the changes that you have made in the settings.
• Restore Settings
Select this choice to cancel the changes that you have made in the settings and restore the previous
settings.
• Load Default Settings
Select this choice to cancel the changes that you have made in the settings and restore the factory
settings.
242
ThinkServer TD200x Hardware Maintenance Manual