Installing A Dvd (Optical) Drive - Lenovo ThinkServer TD200x Hardware Maintenance Manual

Installing a DVD (optical) drive

To install a DVD (optical) drive
1. Read the safety information that begins on page Safety information.
2. Turn off the server and peripheral devices and disconnect the power cords and all external cables.
3. Unlock and remove the left-side cover (see Removing the left-side cover).
4. Install the rails on the sides of the DVD drive.
5. Connect one end of the DVD drive cables to the rear of the DVD drive.
6. Slide the drive into the server.
7. Connect the other end of the DVD drive cables to the optical power connector on the system board.
(See System-board internal connectors for cable connector locations and Internal cable routing and
connectors for cable routing information.)
8. Replace the left-side cover and bezel; then, lock the side cover and bezel.
9. Reconnect the external cables and power cords.
If you have other devices to install or remove, do so now. Otherwise, go to Completing the installation.
1 , do the following:
.
Chapter 7 Installing optional devices and replacing customer replaceable units
181