Removing An Extender Card - Lenovo ThinkServer TD200x Hardware Maintenance Manual
Hardware maintenance manual for td200x
Hide thumbs
Also See for ThinkServer TD200x:
- Hardware maintenance manual (304 pages) ,
- Installation and user manual (246 pages) ,
- Installations- und benutzerhandbuch (246 pages)
Table of Contents
Advertisement
Removing an extender card
1
Extender card retaining screws
To remove an extender card, complete the following steps:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the side cover (see Removing the left-side cover).
5. Remove any adapters that are installed in the expansion slots (see Removing an adapter).
6. Remove the system board and place it on a static-protective surface (see Removing the system board).
Note: Do not remove the DIMMs, heat sinks, microprocessors, VRM, or battery from the system board.
7. Remove the two screws that secure the extender card to the system-board tray.
.
Chapter 7
Installing optional devices and replacing customer replaceable units
197
Advertisement
Table of Contents
