Lenovo ThinkServer TD200x Hardware Maintenance Manual page 45

• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Parts Listing, TD200x Machine Types 3719, 3821, 3822, and 3823 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a trained service technician.
A diagnostic interrupt has
occurred on system %1. (%1 =
CIM_ComputerSystem.ElementName)
A bus timeout has occurred
on system %1.(%1 =
CIM_ComputerSystem.ElementName)
A software NMI has occurred
on system %1. (%1 =
CIM_ComputerSystem.ElementName)
The System %1 encountered
a POST Error.(%1 =
CIM_ComputerSystem.ElementName)
Error An operator information
panel NMI/diagnostic
interrupt has occurred.
Error A bus timeout has occurred.
Error A software NMI has
occurred.
Error A POST error has
occurred.(Sensor = ABR
Status)
If the NMI button on the system
board has not been pressed,
complete the following steps:
1. Make sure that the NMI
button is not pressed.
2. Replace the operator
information panel cable.
3. Replace the operator
information panel.
1. Remove the adapter from the
PCI slot that is indicated by
a lit LED.
2. Replace the extender card.
3. Remove all PCI adapters.
4. (Trained service technicians
only) Replace the system
board.
1. Check the device driver.
2. Reinstall the device driver.
1. Recover the server firmware
from the backup page (see
Recovering from a Lenovo
ThinkServer Server Firmware
update failure).
2. Update the server firmware
to the latest level.
Important: Some cluster
solutions require specific
code levels or coordinated
code updates. If the device
is part of a cluster solution,
verify that the latest level of
code is supported for the
cluster solution before you
update the code.
.
Chapter 5 Diagnostics
37