Recovering From A Lenovo Thinkserver Server Firmware Update Failure - Lenovo ThinkServer TD200x Hardware Maintenance Manual

Table 4. DSA messages (continued)
• Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
• See Chapter 8 "Parts Listing, TD200x Machine Types 3719, 3821, 3822, and 3823" on page 221 to determine
which components are customer replaceable units (CRU) and which components are field replaceable
units (FRU).
• If an action step is preceded by "(Trained service technician only)," that step must be performed only by
a Trained service technician.
Message
number Component Test
405-907-xxx Broadcom
Ethernet
Device

Recovering from a Lenovo ThinkServer Server Firmware update failure

If power to the server is interrupted while you are updating the Lenovo ThinkServer Server Firmware, the
server might not restart correctly or might not display video. If this happens, complete the following steps
to recover:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Unlock and remove the side cover (see Removing the left-side cover).
4. Locate JP6 on the system board and remove any adapters that impede access to the jumpers.
State Description
Test LEDs Failed
Action
1. Make sure that the component firmware is
at the latest level. The installed firmware
level is shown in the DSA log in the
Firmware/VPD section for this component.
For more information, see Updating the
firmware.
2. Run the test again.
3. Replace the component that is causing
the error. If the error is caused by an
adapter, replace the adapter. Check the
PCI Information and Network Settings
information in the DSA log to determine the
physical location of the failing component.
4. If the failure remains, go to the Lenovo Web
site for more troubleshooting information at
http://www.lenovo.com/support.
Chapter 5
117
.
Diagnostics