Lenovo ThinkServer TD200x Hardware Maintenance Manual page 191

To install a tape drive, do the following:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Unlock and remove the left-side cover (see Removing the left-side cover for more information).
4. Open the bezel by pressing on the bezel retention tab at the center-left edge of the bezel and rotating
the left side of the bezel away from the server (see Removing the bezel).
5. Remove the EMC shields
6. Find the blue drive rails in the server bay and install one on each side of the tape drive.
7. Slide the tape drive
8. Close the bezel.
9. Remove the power supplies from the rear of the server.
10. Carefully lay the server down on its side.
11. Open the power-supply cage (see Opening the power-supply cage for more information).
12. Remove the air baffle (see Removing the air baffle for more information).
13. Remove the fan-cage assembly.
1 from the drive bays.
2 into the server.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
183