Removing The Usb Cable And Easyled Panel - Lenovo ThinkServer TD200x Hardware Maintenance Manual

1
SATA optical drive power connector
2
USB signal cable connector
3
USB signal cable
4
SATA optical drive power cable (SATA-to-traditional power connector cable also included. Not
pictured.)
5
SATA optical drive signal cable
15. Connect one end of the tape drive cable to the USB or SATA connector on the system board, depending
upon the type of tape drive that you are installing; then, route the cable through the cable holders on the
inside of the server and connect the opposite end of the cable to the back of the tape drive.
Note: If you are installing an RDX internal USB tape drive, use the SATA-to-traditional power converter
cable to serve as a bridge between the optical power cable and the power connector on the RDX
tape drive.
16. Connect the power cable to the tape drive and to the connector on the system board (see Internal cable
routing and connectors for more information.)
17. Reinstall the fan-cage assembly.
18. Reinstall the air baffle (Installing the air baffle).
19. Reinstall or close the power-supply cage (Closing the power-supply cage).
20. Reinstall the power supplies (Installing a hot-swap power supply).
21. Replace the left-side cover; then, lock the side cover and bezel.
22. Reconnect the external cables and power cords.
If you have other devices to install or remove, do so now. Otherwise, go to Completing the installation.

Removing the USB cable and EasyLED panel

1
Spring clips
To remove the USB cable and EasyLED panel from the server, complete the following steps:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and peripheral devices; then, disconnect the power cords and all external cables.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
185