Updating The Server Configuration - Lenovo ThinkServer TD200x Hardware Maintenance Manual

1
USB 1
2
USB 2
3
USB 3
4
USB 4
5
Ethernet 10/100/1000
6
Power cord connector

Updating the server configuration

When you start the server for the first time after you add or remove an internal option or an external device,
you might receive a message that the configuration has changed. The Setup Utility starts automatically so
that you can save the new configuration settings. For additional information, see Chapter 9 "Configuring
the server" on page 239.
The server comes with at least one microprocessor. If more than one microprocessor is installed, the
server can operate as a symmetric multiprocessing (SMP) server. You might have to upgrade the operating
system to support SMP. For more information, see "Typical operating system installation" on page 251and
the operating-system documentation.
If the server has an optional RAID adapter and you have installed or removed a hard disk drive, see the
documentation that comes with the RAID adapter for information about reconfiguring the disk arrays.
For information about configuring the integrated Gigabit Ethernet controller, see "Configuring the Gigabit
Ethernet controller" on page 253"Configuring the Gigabit Ethernet controller" on page 266.
220
ThinkServer TD200x Hardware Maintenance Manual
7
Power-error LED
8
dc-power LED
9
ac-power LED
10
Video
11
Serial 1 (COM 1)
12
Systems management