Altigen AltiContact Manager Version 4.6 Administration Manual page 218

Setting General Trunk Attributes
Figure 7. Triton T1 Configuration dialog box
The following are the parameters for the Triton T1 Configuration dialog
box:
Parameter
T1 robbed-bit signaling
Protocol
Dialing Delay
Caller ID and DID Collection
7-16 AltiContact Manager Administration Manual
Description
You can set Protocol to one of the following:
• E&M Wink Start (default)
• E&M Immediate Start
• Ground Start
• Loop Start
For signaling from one board to another, only FXS
(Foreign Exchange Subscriber) is supported. Loop Start
and Ground Start protocols cannot be used for interfacing
between two boards.
Specifies the delay, in milliseconds, after trunk seizure and
before digit dialing. Do not change this value unless
advised.