Managing The Configuration File; Backup Settings - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
The STM MIB structure is automatically downloaded by management stations. You should start
receiving notifications after you have enabled SNMP on the STM and added its IP address into
your MIB browsers.

Managing the Configuration File

The configuration settings of the STM are stored in a configuration file on the STM. This file can
be saved (backed up) to a PC, retrieved (restored) from the PC, or cleared to factory default
settings.
Once the STM is installed and works properly, make a back-up of the configuration file to a
computer. If necessary, you can later restore the STM settings from this file. The Backup and
Restore Settings screen lets you:
• back up and save a copy of the current settings
• restore saved settings from the backed-up file
• revert to the factory default settings.
To display the Backup and Restore Settings screen, select Administration > Backup and Restore
Settings from the menu.
Figure 3-9

Backup Settings

The backup feature saves all STM settings to a file. These settings include:
• Network settings. IP address, subnet mask, gateway, and so on.
• Scan settings. Services to scan, primary and secondary actions, and so on.
3-16 Performing Network and System Management
v1.0, September 2009