Using Program Individual Functions And Program Common Functions - Brother Z-8550B Instruction Manual

Using program individual functions and program common functions

• In addition to start backtack sewing, main sewing and end backtack sewing, the following 6 types of functions
are also included in the parameters which are necessary for sewing.
Needle up/down, thread trimming lock, thread wiping (Z-8560B), correction sewing, AUTO, slow start.
• Of these 6 types of functions, the functions which can be set separately for each program are called "program
individual" functions.
When an assignment is made to a program individual function, a "P" symbol appears in the top-left corner of the
icon.
On the other hand, the functions which can be set in common for all programs (P1 to P9) are called "program
common" functions.
• Each of the 6 types of functions can be set to be used as either a program individual function or a program
common function. (Memory switch No. 301 to No. 306)
At the time of shipment from the factory, the settings are as follows.
Needle up/down
Thread trimming lock
Thread wiper
(Z-8560B)
Correction sewing
AUTO
Slow start
Needle up/down
This sets whether the needle bar stops in the up position or the down position when the treadle is returned to the
neutral position and sewing stops.
Thread trimming lock
This sets the thread trimming operation when the treadle is depressed backward.
Program individual functions
×
×
×
×
○
×
Needle stops in the down position.
However, the needle will stop in the up position when the treadle is depressed
backward, and after thread trimming (needle raised) during automatic sewing.
Needle stops in the up position.
Program common functions
○
○
○
○
×
○
Setting details
52