Maintenance; Method Of Removing The Toner Soiling Which Comes In Contact With Heat Roller And Press Roller - Kyocera Mita FS-C5016N - Color LED Printer Service Manual

FS-C5016N

1-4-2 Maintenance

(1) Method of removing the toner soiling which comes in contact with heat roller and Press roller

When misfeeding has occurred in the fuser unit, misfeed paper can coil around the heat roller or the press roller. Remov-
ing the misfed paper will cause, there are times when the toner soiling remains in the heat roller or the press roller. Follow
the procedure below in this case and remove the toner soiling from the heat roller or the press roller.
1. Remove the misfed paper. Cancel misfeed by opening and closing a cover. wait until the message display shows
"Ready".
2. Press [MENU] and set paper type to [Transparency] and paper source to [MP tray].
3. Set the a sheet (transparency sheet [3M CG3700] or thick paper with the of more than weight above 135 g/m
tray.
4. Press [MENU] and print a status page. (The toner soiling which comes in contact with the heat roller and the press
roller will be transferred onto paper).
5. Until the toner soiling is cleared, repeat (Usually when 4 - 5 it prints, the soiling goes out) the above procedure.
1-4-14
) to MP
2